DataCAD-DBUG

Not sure if he still reads these but David Bergman is a long time Datacad user. I've cc'd him

George and Wendell remain inspirations to me. Lives well lived. I find it beautiful that his wife

AGENDA for SEPTEMBER 2019 DBUG MEETING WHEN: Wednesday, September 11, 2019 6:00 pm WHERE: Neil

To Boston Area DBUGers, DBUG is ready to get rolling again with our next meeting, now set for

All, OK. Got it. Worked as directed. Thank you very much for the group of replies. A little used

No, but I bet you forgot to tick the raytrace box at bottom right of the save dialogue box. That is

From our old Datacad LLC friend Prasad Dixit https://www.enverter.com/ David K. Sargert, LEED AP 713-

One can always customize Alt-* commands. Several of mine are. You probably have some, too. Just write

Hi David, Are you referring to the Open dialog??? Do you want to have Sessions files created??? If so

n 11/06/2019 3:55 am, Mike Backler wrote: > Good Day All > > This has happened once before

Although I think we know most of the people actively using DataCAD in the Boston area, we're

Thank you! David K. Sargert, LEED AP 713-264-1883 (sent from my IPad please excuse typos and silly

That is the best solution, for sure! On 5/13/2019 11:10 AM, Joseph T. Deppe wrote: Neil and Forum, I

I wish there was a keyboard toggle that would change the Print / Setup between Normal (landscape) and

DBUG MAY 2019 MEETING at SEAGLASS ARCHITECTS (Directions below) WHEN: Wednesday, May 15, 2019 at 6 pm

Hi folks, Prasad Dixit posted a very interesting thread on the DataCAD forum: https://www.datacad.com

Found Zamzar online file converter, turned .doc into .bmp, imported. Mal

to my wordy post -- basically, how would I get a .doc file into another supported file which I assume

I have a remote project in Beijing, a real one-off. I will send them my typical drawings noted up in

Boston Area DBUGers, Please join us at our newest meeting site, Seaglass Architects in Peabody, for

Hi Joe, There is a toolbar that does this - it is called Draw.?? When you click on the Draw walls

Hi Neil, Thanks - I do know about the draw icon and it works exactly as you say. I have programmed my

Thanks for your comment. I have tried to get an Intellimouse Explorer before, but to no avail. They

Um, just plot PDF files. Then, if you have Adobe Acrobat Pro, create binders of the PDFs, in the

I am forward this thread to the DBUG forum, as it could help someone, if they have had similar issues

Hello Forum: I have been running DataCAD 16 on my Windows 7 office laptop since 2013. I upgraded to

Not "ballon" frame: BALLOON frame. As in the floaty thingies. Balloon framing was common

I usually work in 3d mode and find that when I copy from one file layer to another my 3d symbols seem

Hi Mike, The first thing I would check is the BAK file - if you saved it TWICE as you exited, then

Try this https://www.datacad.com/bbs/viewtopic.php?f=5&t=16316 David K. Sargert, LEED AP 713-264-