cut them out with the bandsaw | put the stock on the blank that fits | add a little bit of detail | mark on the end of the recoil pad | remove the wood | flattening down the area and getting ready | removing the bulk of the wood | rasped it down to almost the size of the recoil pad | make the pistol grip thinner then reduce the cheek piece a bit | get into some of the concave nooks and crannies | leave it just above the level of the recoil pad | put the other stock in next to it side by side | chisel off the sides | put grease on the bottom of the action | chisel off the high points | put grease on the bolt | stop the vise crushing the newly hollowed out inlet | getting rid of some of the excess wood around the ebony tip | cut off an angle of the fore end | glued on the ebony tip with gorilla wood glue | use about 100 grit sandpaper | remove one of its corners | sanding it with a bit of wood | dremeling out a little bit more clearance on the magazine | putting in the two little flutes either side of the cheek | remove a lot of wood | put the final finish on the gun stock